480
个编辑
更改
→frps服务下的防火墙端口开启
</pre>
* 内网机器上面执行 tail -f nohup.out 查看启动命令的执行结果akerlu
===firewall常用命令===
* 安装firewall命令
<pre>
yum install firewalld firewalld-config
</pre>
* Firewall开启常见端口命令
<pre>
firewall-cmd --zone=public --add-port=80/tcp --permanent
firewall-cmd --zone=public --add-port=443/tcp --permanent
firewall-cmd --zone=public --add-port=22/tcp --permanent
firewall-cmd --zone=public --add-port=53/udp --permanent
</pre>
* Firewall关闭常见端口命令
<pre>
firewall-cmd --zone=public --remove-port=80/tcp --permanent
firewall-cmd --zone=public --remove-port=443/tcp --permanent
firewall-cmd --zone=public --remove-port=22/tcp --permanent
firewall-cmd --zone=public --remove-port=53/udp --permanent
</pre>
* 指定特定源IP访问某端口
<pre>
firewall-cmd --permanent --add-rich-rule="rule family="ipv4" source address="192.168.100.1" port protocol="tcp" port="80" accept" #添加源IP 192.168.100.1访问80端口
firewall-cmd --permanent --add-rich-rule="rule family="ipv4" source address="192.168.100.0/24" port protocol="tcp" port="80" accept" #添加IP段访问80端口
firewall-cmd --permanent --remove-rich-rule="rule family="ipv4" source address="192.168.100.1" port protocol="tcp" port="80" accept" #删除源IP 192.168.100.1访问80端口
</pre>
* 指定特定源IP开放所有端口
<pre>
firewall-cmd --permanent --add-rich-rule="rule family="ipv4" source address="192.180.10.10" accept"
firewall-cmd --reload
</pre>
* 批量添加区间端口
<pre>
firewall-cmd --zone=public --add-port=4400-4600/udp --permanent
firewall-cmd --zone=public --add-port=4400-4600/tcp --permanent
</pre>
* 查看端口列表：
<pre>
firewall-cmd --permanent --list-ports
firewall-cmd --permanent --list-all
firewall-cmd --permanent --list-rich-rules
</pre>
* 其他常用命令
** 启动服务：systemctl start firewalld
** 关闭服务：systemctl stop firewalld
** 重启服务：systemctl restart firewalld、firewall-cmd --reload
** 查看服务状态：systemctl status firewalld、firewall-cmd --state
** 开机自启服务：systemctl enable firewalld
** 开机禁用服务：systemctl disable firewalld
** 查看是否开机自启：systemctl is-enable firewalld
=NAS端安装FRPC=
